Readers ask: Can I Use A Regular Heatgun To Shrinkwrap A Boat?

Can you use a propane torch to shrink wrap a boat?

Propane torches are basically flamethrowers not meant for shrink wrapping, and pointing one at your boat’s hull is ill-advised! If you think a good heat gun costs too much, consider this: You’ll be using it for years to come, so the cost will even out.

Can you use a torch for shrink wrap?

In certain circumstances it can be necessary or time saving to apply heat shrinkable tubing with a torch. When electricity is not available, when the heating capacity of a heater is insufficient or when the proces would be to time consuming, the use of a gas torch can be the choice to maken.

What do I need for shrinkwrap?

Things You’ll Need

  1. Scissors.
  2. Hairdryer.
  3. Impulse sealer.
  4. Heat gun.
  5. Shrink-wrap film.
  6. Item to shrink wrap.

Do you need to shrinkwrap a boat?

The main reason to shrink wrap your boat is to protect it from weather damage. Essentially the shrink wrap is used as a protective cover for the boat and equipment from potentially harsh weather conditions. Shrink wrap will help protect against rodents, insects, bird droppings, and dust.

You might be interested:  Readers ask: Can The Cops Board Your Boat Without A Warrant?

Does PVC shrink when heated?

Like all materials, PVC expands with increasing temperatures and contracts with decreasing temperatures. Because the length-to-diameter ratios of PVC pipe and conduit products are generally very large, length change from temperature variation is the most noticeable.

Can you use a hair dryer on heat shrink tubing?

A hair dryer (or blow dryer) can sometimes be used instead of a heat gun. Blow dryers are just small heat guns, after all. To use a hair dryer on heat shrink, simply set it to its highest heat setting and hold its nozzle close to the tubing until it shrinks.

Which is thicker 70 gauge or 80 gauge?

The higher the gauge mil or micron, the thicker the plastic, and the more durable the product. 70 Gauge – Ideal for loads up to approximately 1600 lb. 80 Gauge – The most common thickness of stretch wrap. Ideal for loads up to approximately 2200 lb.

How much does it cost to get a boat shrink wrapped?

Professional boat shrink wrappers use the boat’s size to determine the final amount. When you have the boat covered by a professional, you should plan on spending $12-25 per square foot. You can save a little money if you do the work yourself.

Can you tow a boat that has been shrink wrapped?

Like the others have said, shrink wrapping will be fine for towing.

How long does shrink wrap last on a boat?

However, we’ve seen the occasional customer keep our wrap on their boat for years with success – but it’s not typical. In short, it all depends on the stress presented by the environment, but 6 months to a year is a reasonable expectation.

Leave a Reply

Your email address will not be published. Required fields are marked *