Readers ask: Can U Lay A Boat Motor On Its Side?

What side do you lay a boat motor on?

Always lie it on the throttle side, not the gear lever side.

Can I lay a 2 stroke outboard on its side?

“ Stowing a motor vertical is just fine for a 2-stroke motor, because a 2-stroke outboard has its oil mixed in the gas, so there isn’t an issue.” This causes excessive smoking when an engine is started, and over time may cause motor damage.

Do outboard motors need to be stored upright?

The best way is to either leave the motor on the boat or on an engine stand in an upright position, not tilted. Also, don’t store the motor with the gearbox higher than the powerhead, since any water in the exhaust passages can run into the cylinders and cause serious damage.

Can you put a 4 stroke outboard on its side?

1. Lay the engine on the correct side. All portable 4-strokes have supports to indicate which side they should be laid on the floor. This makes a mess but only causes long-term damage if you fail to replace the lost oil before starting the engine.

You might be interested:  Often asked: Can You Take Boating Lisense Online In Flordia?

What is a transom saver?

The transom saver is a device that protects your boat’s transom from stress or eventual damage from forces exerted on it by the weight of the outboard while you are trailering it. It is a bar that extends from the outboard to your trailer.

What side do you lay a Yamaha 4 stroke outboard?

Yamaha’s are stored handle down, if you’re gong to lay them on their side.

How do you carry an outboard motor in a car?

The Solution:

  1. Lay your outboard motor onto the trolley, slide the motor along onto the trolley and clamp your motor onto the RT Trolley.
  2. Wheel to trolley to the boat and stand in place so that the bottom clamps fit into the gunnel.
  3. Slide the adjustable legs up into the top gunnel and lock in place.

Is it bad to run an outboard engine at full throttle?

Does this mean an engine should never run at wide-open throttle (WOT)? Absolutely not. Modern engines are designed to handle WOT. Also, during break-in going to WOT, as prescribed by the owner’s manual, is necessary to properly seat the pistons’ rings.

How low should my outboard sit in the water?

A boat rigger’s rule of thumb is that the motor can be raised one inch for each eight to 10 inches of distance between the transom and prop. As the prop moves further aft, it’s also likely to be in cleaner, “harder” water, and be more efficient.

Why is Evinrude not making motors anymore?

Company says it will no longer make Evinrude outboard boat engines, citing impact from coronavirus. Company president and CEO José Boisjoli said, “Our outboard engines business has been greatly impacted by COVID-19, obliging us to discontinue production of our outboard motors immediately.

You might be interested:  Question: Can You Drive A Boat If You Have A Owi?

How do you store a 4 stroke boat motor?

Extend the Life of Your Outboard Engine with These Storage Tips

  1. Flush out the engine with fresh water.
  2. Add fuel stabilizers.
  3. Keep the fuel tank full.
  4. Fog the engine cylinders and carburetor intakes to help slow corrosion.
  5. Change the oil in four-stroke engines.
  6. Drain and replace gear case lubricant.

Leave a Reply

Your email address will not be published. Required fields are marked *